Kudux Hot Beam 10R, User Manual

Page: 9 / 15

WWW.KUDUX.COM 9
2.4.2. Set Light work mode
Enter the page of ‘WORK MOD’ as shown in Figure 8 and modify setting. Can set light work
mode, control lamp and DMX channel mode..
Light includes 3 work mode: DMX MODE, AUTO RUN and SOUND MODE, Parameter definition as
following:

DMX Mode
：
Under this mode, the light receive data from the DMX controller and move.

AUTO RUN
：
Under this mode, light will run with inside code(data), ignore data from DMX
controller.

SOUND Ctrl
：
Under this mode, light ignore data from DMX controller., When there is
a strong sound in stage, the light will run a scene, otherwise it will keep the last scene.

M/S Choose
：
’M/S Choose’ is available when light just in ‘AUTO RUN’ or ‘SOUND Ctrl’
mode. If this item is set as ‘OFF’, the light don’t send data to other light via DMX Cable.
When ‘ON’, the data will send to other slave light immediately.

Lamp control
：
Turn on lamp when this item is set ‘ON’, otherwise, turn off lamp. The
gap between operation is limited to 30 second.

Channel mode
：
Light support 2 DMX Channel mode: sample or extend.
Figure 8 page of work mode
2.4.3. Set display
Light support 2 language, rotation display
，
Enter page as shown in Figure9 to set parameter
following:

Language
：
Select display as simplified Chinese or English.

Screen Saver
：
when panel is idle(these is no operation in 10 second), displayer will
enter saver status. When set as ‘mode 1’
，
saver status is close display, as ‘mode 2’
saver status will display DMX address code(DMX MODE) or display LOGO(AUTO RUN or
SOUND CTRL). As ‘OFF’, keep light up displayer and show main menu
。

Screen Rotation
：
rotate displayer.

Touch enable
：
Disable or enable touch function, when disable, use encoder to operate
light and set parameter.

Touch adjust
：
adjust touch function, normally, not enter this item.
Figure 9 page of display