Kubota WSM L4400, Workshop Manual, Page: 27 / 31

L4400, WSM GENERAL
G-14
Replacing Engine Oil Filter Cartridge
A
Be sure to stop the engine before changing oil filter
cartridge (1).
A
Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the engine oil filter cartridge (1).
2. Put a film of clean engine oil on rubber seal of new filter.
3. Tighten the filter quickly until it contacts the mounting surface.
Tighten filter by hand an additional 1/2 turn only.
4. After the new filter has been replaced, the engine oil normally
decreases a little. Make sure that the engine oil does not leak
through the seal and be sure to check the oil level on the
dipstick. Then, replenish the engine oil up to the prescribed
level.
A
To prevent serious damage to the engine, replacement
element must be highly efficient. Use only a KUBOTA
genuine filter.
Changing Transmission Fluid
A
Be sure to stop the engine before checking and changing
the transmission fluid.
1. Place an oil pan underneath the transmission case.
2. Remove the drain plugs (1) at the bottom of the transmission
case.
3. Drain the transmission fluid.
4. After draining, reinstall the drain plugs (1).
5. Fill with the new KUBOTA SUPER UDT fluid up to the upper
line of the gauge (2).
6. After running the engine for a few minutes, stop it and check
the fluid level again, if low, add fluid prescribed level (A).
A
Use only multi-grade transmission fluid. Use of other
fluids may damage the transmission or hydraulic system.
A
Refer to "LUBRICANTS, FUEL AND COOLANT". (See
page G-8.)
A
Never work the tractor immediately after changing the
transmission fluid. Keeping the engine at medium speed
for a few minutes to prevent damage to the transmission.
A
Do not mix different brands oil together.
(1) Engine Oil Filter Cartridge
0000005035E
Transmission fluid Capacity
40 L
10.6 U.S.gals
8.8 Imp.gals
(1) Drain Plug A : Oil level is acceptable within
(2) Gauge this range.
(3) Filling Plug
0000008225E
KiSC issued 04, 2006 A