16. Using a lift strap or chains, connect the two lift bolts to an over head hoist or forklift and lift
the cab off of the shipping pallet a couple feet.
17. Loosen the front and rear cab mounting brackets so that the brackets could move a little
prior to installation.
18. Lift the cab over the tractor.
19. Slowly lower down until the mounting brackets are sitting onto the operator platform. The
rear bracket will line up with the four mounting holes in the 2-post ROPS. The left and right
front brackets will align with the holes drilled in steps 3 and 4.
20. Re-use the 2-post fasteners and get the rear bracket fasteners started. Do not tighten, only
start the fasteners. The front brackets use
½”
x 1 ½”
flange bolts and nuts. Take the LEFT
plat
form support and position underneath the platform with the 1/2” bolts through the top.
The factory bolts removed earlier will go through the other holes in the support bracket onto
the chassis. Repeat for the right side.
June 2021© Kubota Fx80 Series ROPS Cab Installation Manual
