Kubota M7-132, Operator'S Manual

Page: 214 / 332

2.3 High-hitch with ball trailer coupling
(1) Piton-fix
(2) Retainer
(3) Pin
(4) Lynch pin (A) “LOCK”
(B) “UNLOCK”
3. Piton-fix
WARNING
To avoid personal injury or death:
• Never pull from the top link, the rear axle or any
point above the piton-fix. Doing so could cause
the tractor to tip over rearward causing
personal injury or death.
NOTE :
• For information about the piton-fix load, read
the implement limitations section of this
manual.
(See IMPLEMENT LIMITATIONS on page 36.)
(1) Piton-fix
(2) Retainer
(3) Pin
(4) Lynch pin
TYPE B (HITCH MADE BY
DROMONE)
1. Auto hitch (push back type)
WARNING
To avoid personal injury or death:
• Never pull from the top link, the rear axle or any
point above the hitch. Doing so could cause the
tractor to tip over rearward causing personal
injury or death.
• Make sure the latch hook is locked before
towing an implement.
To lower the hitch
1. Start the engine and set the lift arm top limit to its
highest position.
Turn the depth control dial fully clockwise to raise
the lift arm to its topmost position.
(1) Lift arm top limit adjustment
dial
(2) Depth control dial
(A) “HIGH”
(B) “UP”
(1) Lift arm top limit adjustment
control
(2) Depth control dial
(A) “HIGH”
(B) “UP”
2. Pull the auto hitch release lever to unlock the latch
hooks and the latch bar from each other.
3-POINT HITCH AND DRAWBAR TYPE A (HITCH MADE BY SCHARMÜLLER )
208
M7132, M7152, M7172