Kubota M5660SUH, Operator'S Manual

Page: 110 / 117

PERIODIC SERVICE 88
B
Replacing Slow-Blow Fuses
The slow-blow fuses are intended to protect the electrical
cabling. If any of them has blown out, be sure to pinpoint
the cause. Never use any substitute, use only a KUBOTA
genuine part.
C Replacement procedure
[Non bolt fixed slow-blow fuse:]
1. Disconnect the negative cord of the battery.
2. Pull out the fuse from the fuse box.
3. Replace with a new one of the same capacity.
[Bolt fixed slow-blow fuse:]
Consult your local KUBOTA Dealer for this service.
B Replacing Light Bulb
Fuse
No.
Capacity
(A)
Protected circuit
(1) 15 ECU
(2) 5 Operation
(3) 15 Loader Plug
(4) 5 Meter Panel
(5) 5 PTO
(6) 10 Turn Signal
(7) 15 Flasher
(8) 5 ECU (Backup)
(9) 15 Head Light
(10) 5 Meter (Backup)
(11) 15 Work Light
(12) 5 Main Key
(13) 20 CRS Power
(14) 5 Air Flow Sensor, EGR Valve
(15) 5 Feed Pump
No. Capacity Protected circuit Type
1 50A Charge
Bolt fixed
2 50A
Engine preheat
Starter
3 40A
Head lamp
Key switch
Work light
Non Bolt
fixed
(1) Fuse box
(2) Bolt
(3) Bolt fixed slow-blow fuse
(4) Non bolt fixed slow-blow fuse
Light Capacity
Head light 12 V, 55 / 60 W (H4)
Hazard light 12 V, 23 W
Turn signal 12 V, 21 W
Tail light 12 V, 5 W
Work light (if equipped) 12 V, 35 W