Kubota M4N-071, Operator'S Manual

Page: 126 / 152

2. After draining reinstall the drain plug.
(1) Drain plug
3. Remove the oil filter.
4. Wipe off metal filings from the magnetic filter with a
clean rag.
(1) Hydraulic oil filter
(2) Magnetic filter (wipe off metal filings)
5. Put a film of clean transmission oil on the rubber
seal of the new filter.
6. Tighten the filter quickly until it contacts the
mounting surface.
Tighten filter by hand an additional 1/2 turn only.
7. After the new filter has been replaced, fill the
transmission oil up to the upper notch on the
dipstick.
(1) Gauge (A) Oil level is acceptable within
this range.
8. After running the engine for a few minutes, stop the
engine and check the oil level again, add oil to the
prescribed level.
9. Make sure that the transmission fluid does not leak
past the seal on the filter.
IMPORTANT :
• To prevent serious damage to the hydraulic
system, use only a KUBOTA genuine filter.
5. Checking power steering line
1. Check to see that all lines and hose clamps are
tight and not damaged.
PERIODIC SERVICE EVERY 500 HOURS
120
M4N-071, M5N-091, M5N-111