Kubota M4N-071, Operator'S Manual

Page: 103 / 152

LUBRICANTS, FUEL AND COOLANT
No. Locations
Capacities
Lubricants
M4N-071 M5N-091 M5N-111
1 Fuel
76 L
(20.1 U.S.gals.)
No.2-D S15 diesel fuel
No.1-D S15 diesel fuel if temperature is below -10
℃
(14
℉
)
2 DEF/AdBlue
®
---
12.3 L
(3.2 U.S.gals.)
3 Coolant
10 L (11 U.S.qts.)
(Recovery tank: 1.0 L (1.1 U.S.qts.))
Fresh clean soft water with antifreeze
4
Engine crankcase
(with filter) 10.7 L
(11.3 U.S.qts.)
• Engine oil:
API service classifica-
tion
CJ-4
(DPF type engine)
Above 25 ℃ (77 ℉ )
SAE30,
SAE10W-30 or 15W-40
-10 ℃ to 25 ℃ (14 to 77 ℉ ) SAE10W-30 or 15W-40
Below -10 ℃ (14 ℉ ) SAE10W-30
5 Transmission case
52 L
(54.9 U.S.qts.)
• KUBOTA SUPER UDT2 fluid*
6
Front differential case
oil 5 L
(5.3 U.S.qts.)
• KUBOTA SUPER UDT2 fluid* or SAE 80 - SAE 90 gear
oil
7 Front axle gear case oil
3 L
(3.2 U.S.qts.)
8
Greasing No. of greasing points Capacity Type of grease
Top link 2
Until grease overflows.
Multipurpose grease
NLGI-2 or
NLGI-1 ( GC-LB )
Top link bracket 2
Lift rod 2
Hydraulic lift cylinder
pin
4
Front axle gear case
support
2
Front axle support 2
Steering joint shaft 1
Battery terminal 2 A small amount
NOTE :
• The product name of KUBOTA genuine UDT fluid may be different from that in the operator's manual
depending on countries or territories. Consult your local KUBOTA Dealer for further details.
Engine oil
• The oil used in the engine should have an American Petroleum Institute (API) service classification and proper
SAE engine oil according to the ambient temperatures shown in the previous table.
• Refer to the following table for the suitable API classification engine oil according to the diesel particulate filter
(DPF) type engines and the fuel.
Fuel used
Engine oil classification
(API classification)
Oil class for engines with DPF
Ultra low sulfur fuel
<0.0015% (15 ppm)
CJ-4
Fuel
• Use the ultra low sulfur diesel fuel only (below 0.0015% or 15 ppm) for these engines.
LUBRICANTS, FUEL AND COOLANT MAINTENANCE
M4N-071, M5N-091, M5N-111
97