Operation
76
Fine-tuning the limited oil flow
The fine-tuning comes in 15 stages (0 to 14). The flow rate is set using different steps. "14" represents the
maximum flow rate and "0" the minimum flow rate.
This setting can be preset differently for the connectors at the arm (1) and (2) (figure above).
Setting
The preference for a limited oil flow has been set. The starter switch is now reset to the STOP position.
It is recommended to set this preference during operation of the implement.
•
Press and hold down the flow rate switch (1) and start the
engine. The following message is displayed with the digit
"1" flashing in the display.
•
To adjust the right connector at the arm, either press the
working light button (1) or the service port switch (2). The
display toggles between "0" and "14", depending on the
switch pressed. Set the required value.
•
Upon pressing the working light button (1) the flow rate
decreases.
•
Upon pressing the service port button (2) the flow rate
increases.