6
OPERATING THE ENGINE
EN
GLISH
OPERATING THE ENGINE
STARTING THE ENGINE (NORMAL)
To avoid personal injury or death:
A
Do not allow children to approach the
machine while the engine is running.
A
Be sure to install the machine on
which the engine is installed, on a flat
place.
A
Do not run the engine on gradients.
A
Do not run the engine in an enclosed
area. Exhaust gas can cause air
pollution and exhaust gas poisoning.
A
Keep your hands away from rotating
parts (such as fan, pulley, belt,
flywheel etc.) during operation.
A
Do not operate the machine while
under the influence of alcohol or
drugs.
A
Do not wear loose, torn or bulky
clothing around the machine. It may
catch on moving parts or controls,
leading to the risk of accident. Use
additional safety items, e.g. hard hat,
safety boots or shoes, eye and
hearing protection, gloves, etc., as
appropriate or required.
A
Do not wear radio or music
headphones while operating engine.
A
Check to see if it is safe around the
engine before starting.
A
Reinstall safeguards and shields
securely and clear all maintenance
tools when starting the engine after
maintenance.
A
Do not use ether or any starting fluid for starting the
engine, or a severe damage will occur.
A
When starting the engine after a long storage (of more
than 3 months), activate the starter for about 10
seconds to allow oil to reach every engine part.
A
If the oil pressure lamp stays on after the engine starts
and runs, shut the engine off immediately and check
the following:
- if there is enough engine oil.
- if the engine oil has dirt in it.
- if the wiring is faulty.
If the oil pressure lamp continues to stay on and is not
resolved by checking these items, contact your local
KUBOTA Dealer for service.
1. Set the fuel shutoff-valve to the "ON"
(OPEN) position.
2. Insert the key into the key switch.
3. Turn the key to the "ON" position and
hold it until the heater indicator turns off.
(1) Heater indicator
(A) "OFF" SWITCHED OFF
(B) "ON" OPERATION
(C) "ST" STARTING
4. Turn the key to the "ST" (STARTING)
position and the engine should start.
Release the key immediately when the
engine starts.
5. Check to see that the oil pressure lamp
and charge lamp are off. If the lamps
are still on, immediately stop the
engine, and determine the cause.
(See "CHECKS DURING OPERATION" in
"OPERATING THE ENGINE" section.)
1J778-8915_E.book 6 ページ ２０１６年６月２０日 月曜日 午後５時７分
