
OPERATING THE LOADER
60
LOADING FROM A BANK
Choose a forward gear that provides a safe ground speed
and power for loading.
To avoid the possibility of serious personal injury:
A
Exercise caution when undercutting high banks.
A
Dirt slides can be dangerous. Load from as low as
possible for maximum efficiency.
A
Loader lift and break-away capacity diminish as
loading height is increased.
Side cutting is a good technique for cutting down a big
pile. Wheel width should not exceed the bucket width for
this procedure.
If the pile sides are too high and liable to cause cave-in,
use the loader to break down the sides until a slot can be
cut over the top.
Another method for large dirt piles is to build a ramp to
approach the pile.
It is important to keep the bucket level when approaching
a bank or pile. This will help avoid gouging the work area.
PEELING AND SCRAPING
Use a slight bucket down angle, travel forward, and hold
the lift control forward to start the cut. Make a short cut
and break-out cleanly.
With the bucket level, start a cut at the notch
approximately 5 cm. deep. Hold the depth by feathering
the bucket control to adjust the cutting edge up or down.
When the front tires enter the notch, adjust the boom
cylinder to maintain proper depth.
Make additional passes until the desired depth is reached.
During each pass, use only the bucket control while at
working depth. This will allow you to concentrate on
controlling the bucket angle to maintain a precise cut.
Summary of Contents for BT602
