Kubota B2778, Operator And Parts Manual

Page: 12 / 40

ASSEMBLY
OM 0361BR-AC 10
Figure 1
Figure 2
Figure 2b
Figure 2a
R
OTARY BROOM
A
SSEMBLY
The rotary broom is pre assembled at the factory, however, parts contained in the bag and box must
be installed. Use the present manual and lay out all parts for assembly. Separate bolts and nuts into
various sizes. After assembly, torque all the bolts according to the Torque Specification Table
enclosed at the end of the manual.
Preparation
(Figure 1)
After removing the broom from the wooden
crate, place it on its parking stands by
removing the 1/4" wire lock pin (item 1) and
lowering the parking stand (item 2). Then
insert the wire lock pin (item 1) on the parking
stand (item 2) as illustrated. Follow the same
procedure for the second parking stand.
Driveline Installation
(Figures 2-2a-2b)
1. Figures 2-2a-2b: Slide the outer retaining
ring (item 4) beyond the second groove
(item 2b) of the gearbox shaft (item 2).
Then, slide the driveline (item 1) on the
gearbox shaft (item 2) until the first groove
of the gearbox shaft (item 2a) is visible
and insert the inner retaining ring (item 3)
in that groove.
2. Figures 2-2b: Pull on the driveline (item 1)
until the second groove of the gearbox
shaft is visible (item 2b) and slide the outer
retaining ring (item 4) in it.
3. Figure 2-2b: Secure the driveline (item 1)
to the gearbox shaft (item 2) with the
1/4"NC x 2 1/2" lg hex. bolt (item 5) and
the 1/4"NC nylon insert locknut (item 6).