Kubota AP-SSG2524, Operator'S Manual, Page: 15 / 44

Section 1: Assembly & Set-up
Table of Contents
11/13/19 AP-SSG2524 Stump Grinder 328-215MK
11
Hooking-up to the Stump Grinder
Figure 1-1
Refer to Figure 1-1:
1. Check for and remove any debris in the hitch point
areas before hooking-up to the Stump Grinder.
2. Drive skid steer slowly to the grinder hitch making
sure the skid steer hitch plate is parallel with the
grinder’s top angle bars.
3. Rotate top of skid steer tilt arms slightly forward.
4. Place top of skid steer hitch plate under the top
angled bar on the grinder. Slowly raise hitch plate up
until hitch plate is seated under the top angle bar.
5. Rotate top of skid steer tilt arms back until grinder
makes full contact with hitch plate.
6. Push lock handles on skid steer hitch down so that
the pins go through the bottom slots of the grinder
hitch and make sure handles lock down.
35331
Bottom slots
Return Line (#2) Connects To
Solenoids
Pressure Line (#1) Connects To
Hydraulic Motor
Top Angle Bars
Hydraulic Hose Hook-up
DANGER
!
To avoid serious injury or death:
•
Make sure skid steer has been properly shut down and
pressure to the hydraulics has been relieved.
•
Hydraulic fluid under high pressure can penetrate the skin
and/or eyes causing a serious injury. Wear protective gloves
and safety glasses or goggles when working with hydraulic
systems. Use a piece of cardboard or wood rather than
hands when searching for leaks. A doctor familiar with this
type of injury must treat the injury within a few hours or
gangrene may result. DO NOT DELAY.
o
Kubota Hose Stay Kit
Figure 1-2
IMPORTANT: Hose routing is the responsibility of
the owner/operator of the power machine. Pinched
and/or stretched hoses are not covered under the
warranty.
IMPORTANT:
Make sure coupler fittings on the
hydraulic hoses and power machine are clean
before connecting them together.
NOTE: The Stump Grinder will not operate with
hydraulic hoses hooked-up backwards.
NOTE: If attaching to a Kubota skid steer, route
hydraulic hoses through Kubota’s SVL or SSV Hose
Stay as shown in Figure 1-2. Purchase SVL Hose
Stay #S6689 or SSV Hose Stay #77700-07225
through your nearest Kubota dealer. Refer to your
skid steer Operator’s Manual for more instructions.
37394
Hose Stay Kit