Kubota AP-SRB1566, Operator'S Manual

Page: 12 / 26

Section 1: Assembly & Set-up
Table of Contents
11/11/19 AP-SRB1566, AP-SRB1572, & AP-SRB1578 Skeleton Rock Buckets 380-101MK
8
Section 1: Assembly & Set-up
Power Machine Requirements
The SRB15 Series buckets are designed to attach to a
skid steer type quick attach hitch that meets ISO 24410.
Consult the skid steer/track loader or tractor Operator’s
Manual for operating capacity, lift capacity, and operating
specifications. They will vary from unit to unit. Do not
exceed the rated capacities and specifications of the skid
steer/track loader or tractor.
WARNING
!
To avoid serious injury or death:
•
Consult your power machine’s manual for operating
capacity, lifting capacity, and operating specifications.
Exceeding rated capacities and specifications can result in
a roll-over or other serious hazard.
•
Lightweight power machines may need weight added to the
rear to maintain steering control and prevent forward
tipping or side tipping caused by a heavy front load. Consult
your power machine Operator’s Manual to determine
proper weight requirements and maximum weight
limitations.
Torque Requirements
Refer to
“Torque Values Chart”
on page 18 to determine
correct torque values when tightening hardware.
Before You Start
Make sure that the intended skid steer/tractor conforms
to the “Power Machine Requirements” provided above.
Read and understand this Operator’s Manual and
“Pre-Assembly Checklist” below before assembling
and attaching the bucket to your power machine.
Pre-Assembly Checklist

Check Reference
Have a fork lift or loader with properly sized chains and
safety stands capable of lifting and supporting the
equipment on hand.
Make sure all major components and
loose parts are shipped with the machine.
Assembly
& Set-up
Make sure all safety labels are correctly
located and legible. Replace if damaged.
Page 6
Uncrating Instructions
1. Cut the top of the crating off and lift the crating top
straight up.
2. Attach lifting straps to the upper bucket in a fashion
that will allow the bucket to be raised vertically
without swinging down against the bucket below.
3. While being careful not to make contact with the
bucket below, raise upper bucket straight up and then
gently lower the bucket onto the floor.
4. Finish cutting away the crate and then remove the
bottom bucket. Be careful not to hit other objects or to
scratch the bucket finish in the process.
NOTE:
Do not lift upper bucket in a fashion that will
allow the bucket to swing down and contact the
bucket below. Doing so can damage the buckets.