Section 1: Assembly & Set-up
4/5/19
AP-SRF2772, AP-SRF2790, AP-SR2772, & AP-SR2790 Powered Rakes 321-120MK
13
SR-2772 Gauge Wheel Assembly
Figure 1-2
39763
Hydraulic Motor Hose Assembly
Refer to Figure 1-2:
SR27 Series Only:
Check hoses (#7 & #8) between
bypass valve (#4) and hydraulic motor (#5). Hoses must
arch up to prevent becoming entangled in hitch pivot
points and material control adjustment tubes (#11). Do
the following if hoses (#7 & #8) do not arch up:
1.
Loosen hose (#7) from fitting (#6).
2.
Rotate hose (#7) until it arches-up between bypass
valve (#4) and hydraulic motor (#5).
3.
Hold hose (#7) in this arched-up position and tighten
hose end to fitting (#6).
4.
If not completed, attach hose (#8) to hose (#7) with
zip tie (#10) in the arched-up position to keep both
hoses from becoming entangled in hitch pivot points.
5.
If not completed, attach hose (#8) to hose (#9) with
zip tie (#10) in the vicinity of bypass valve (#4).
Gauge Wheel Assembly
Refer to Figure 1-2:
1.
Attach gauge wheels (#1) to the rear frame with
u-bolts (#3) and 5/8"-11 hex flange locknuts (#2) as
shown. Make sure u-bolts straddle lifting lugs “A” on
the SR2790 & SRF2790 as shown in Figure 1-3.
2.
Tighten hex whiz nuts (#2) to the correct torque for a
grade 5 bolt.
SR-2790 Gauge Wheel Assembly
Figure 1-3
39952
