Kubota AP-SR2672, Operator'S Manual, Page: 14 / 36

10
Section 1: Assembly & Set-up
AP-SR2672, & AP-SR2690 for Skid Steer Powered Rakes 321-004MK 4/10/19
Table of Contents
Gauge Wheel Assembly
Figure 1-1
37789
By-Pass Valve
Hydraulic Hoses
Must Arch Up
Hydraulic
Motor
Section 1: Assembly & Set-up
Skid Steer Requirements
The Powered Rake is designed to fit on Skid Steer
Loaders with the following minimum requirements:
•
SR2672
SAE Lift Capacity. . . . . . . . . . . . . . . . . . . . . 1200 lbs.
Hydraulic Requirements. . . . . . . . 11 gpm at 2200 psi
Maximum Hydraulic Pressure . . . . . . . . . . . .3500 psi
•
SR2690
SAE Lift Capacity. . . . . . . . . . . . . . . . . . . . . 1600 lbs.
Hydraulic Requirements. . . . . . . . 15 gpm at 2500 psi
Maximum Hydraulic Pressure . . . . . . . . . . . .3500 psi
WARNING
!
To avoid serious injury or death:
Lightweight power machines may need weight added to the
rear to maintain steering control and prevent forward tipping
or side tipping caused by a heavy front load. Consult your
power machine Operator’s Manual to determine proper
weight requirements and maximum weight limitations.
Hydraulic Motor Hose Assembly
Refer to Figure 1-1:
Check hoses between by-pass valve and hydraulic
motor. Hoses must arch up to prevent becoming
entangled in the hitch pivot points. If hoses do not arch
up, the following should be done:
1. Loosen hose fittings at the valve by-pass.
2. Rotate hoses until they arch up.
3. Retighten hose fittings.
Gauge Wheel Assembly
Refer to Figure 1-1:
1. Attach gauge wheels (#1) to the rear frame with
u-bolts (#4), lock washers (#3), and nuts (#2) as
shown.
2. Tighten nuts to correct torque.