Section 1: Assembly & Set-Up
4/11/19
AP-SGM1566, AP-SGM1572, & AP-SGM1578 Grapples 380-051MK
11
Skid Steer & Tractor Hook-Up
Refer to Figure 1-4:
WARNING
!
To avoid serious injury or death:
•
•
The Manure Grapple is designed for skid steers and
tractors with front mounted loaders.
1.
Check for and remove any debris in the hitch point
areas before hooking-up to grapple.
2.
Drive skid steer or tractor slowly to the grapple hitch
making sure the hitch plate on the skid steer/tractor is
parallel with the grapple’s top angle bar.
3.
Rotate top of skid steer/tractor tilt arms slightly
forward.
Hook-up to Grapple
Figure 1-4
4.
Place top of skid steer/tractor hitch plate under top
angled bar on grapple and slowly raise hitch plate up
until hitch plate is seated under the top angle bar.
5.
Rotate top of skid steer/tractor tilt arms back until
grapple makes full contact with face of hitch plate.
6.
Push lock handles on skid steer/tractor hitch down
ensuring the pins go through bottom slots in grapple
hitch and make sure handles lock down.
7.
If optional upper grapple fork is included, continue
with
39752
Bottom slots
Top Angle Bar
Top Angle Bar
Installation of Optional Cylinder Shields
Figure 1-3
35424
Shield Pivot Holes
Cylinder Pivot Hole