PRINTED IN THE USA © KUBOTA TRACTOR CORPORATION 2020
Code: 77700-05194 (Rev. K)
4. Attach the dome light to the canopy with a 5/16-18 x 3/4”
long bolt, nylon washer, and nut as shown in fig. 4.
Wiring
5. Starting at the battery compartment, route the end of the
wire harness with the bullet terminals between the foam seal
of the rear panel (if equipped) and the ROPS attachment.
Route the harness up the back of the driver’s side vertical
ROPS tube, over the top of the driver to passenger side
cross tube and along the center tube as shown in fig. 5.
6. Connect the bullet terminals of the wire harness to the
corresponding terminals on the dome light.
7. Connect the ring terminal of the red wire (with in-line fuse
holder) to the positive battery terminal bolt. Connect the ring
terminal on the black wire to the negative terminal bolt and
reconnect the negative battery terminal.
8. Starting at the light, use provided zip-ties to secure the
wiring harness to the ROPS tube. See fig. 5.
Fig. 4
Fig. 5 (shown with canopy removed)
Nut
Bolt
Washer
Canopy
Route between rear panel
seal (not shown) and
ROPS attachment if in-
stalling with rear panel
Zip
Ties
