KUB_65D rev. a
2/2
2. Prepare the gimbal cover, place washers and bolts in the holes.
3. Place the gimbal cover in the correct position, apply Loctite 243 thread locking adhesive to
the bolts and tighten the bolts to 6 Nm in the correct sequence as shown below.
Caution:
If the screws are not properly tightened and secured, vibration during transport may cause
the coupling screws to loosen, fall out and subsequently loosen the burner units from the
burner frame.
Technical content of this document is approved under the authority of DOA No. EASA.21J.277.
On behalf of Kubíček Factory s.r.o.
Ing. Petr Kubíček, technical director
Datum:
28.4.2022
