KTR Kupplungstechnik
GmbH
D-48407 Rheine
C L A M P E X
®
K T R 6 0 3
m o u n t i n g i n s t r u c t i o n s
KTR-N
sheet:
edition:
40821 E
3
1
Gezeichnet: 10.07.01 Sha/Hg
Ersatz für:
Verteiler
Urheberschutz
gemäß DIN 34
Geprüft:
13.07.01 Sha
Ersetzt durch:
W
K
V
VA
M KC
Assembly
Continuation:
•
Loosen the clamping screws slightly and put the clamping set KTR 603 externally onto the hub / hollow shaft.
F
A T T E N T I O N !
In the area of the position of the external clamping set the external surface of the hub
(outside hollow shaft) can be greased.
!
C A U T I O N !
Before tightening the clamping screws install the shaft.
•
Slightly tighten the clamping screws manually and align the external clamping set with hub part / hollow
shaft.
•
Tighten the clamping screws evenly and successively. Increase the tightening torque step by step. This must
be repeated until reaching the tightening torque indicated in table 2 at all clamping screws.
Table 1:
shaft-Ø d
w
[mm]
18 to 30
31 to 50
51 to 80
81 to 500
tolerance
H6 / j6
H6 / h6
H6 / g6
H7 / g6
Table 2:
type of clamping set
KTR 603
screw size M
M5
M6
M8
M10
M12
M16
M20
tightening torque T
A
[Nm]
4
12
30
59
100
250
490
Disassembly
STOP
D A N G E R !
Loosened or falling drive parts can cause injuries to persons or damages to the machines.
Safe the drive parts before the disassembly.
•
Detach all clamping screws evenly and successively. Do not unscrew the clamping screws completely from
the thread.
!
C A U T I O N !
To reduce the tension forces the clamping screws must not be unscrewed completely.
•
The clamping sets are not self-locking. If the front and the back external taper ring don´t loose, the loosing
process must be started by a slight pressure onto the front and the back external taper ring on the
circumference.
•
Remove shaft from the hub / hollow shaft.
•
Draw the clamping set KTR 603 off the hub / hollow shaft.
!
C A U T I O N !
In case of non-observance of these hints or in case of non-considerance of the operating
conditions regarding the selection of the clamping set, the function of the clamping set can
be influenced.
Disposal of waste:
Defective clamping sets must be cleaned and scrapped.
