Oil/air cooler
Series OPC
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
43211 EN
7 of 20
5
Please observe protection
note ISO 16016.
Drawn:
2019-10-23 Pz/Str
Replacing:
KTR-N dated 2017-01-02
Verified:
2019-11-04 Pz
Replaced by:
You may only assemble and disassemble the oil/air cooler if you
•
have carefully read through the operating/assembly instructions and understood them
•
are technically qualified and specifically trained (e. g. safety, environment, logistics)
•
are authorized by your company
The oil/air cooler may only be used in accordance with the technical data (see chapter 1). Unauthorized
modifications on the oil/air cooler are not admissible. We will not assume liability for any damage that may arise.
In the interest of further development we reserve the right for technical modifications.
The
oil/air cooler series OPC
described in here corresponds to the technical status at the time of printing of
these operating/assembly instructions.
The oil/air coolers are supplied in preserved condition and with painting and can be stored at a dry and roofed
place for 6 - 9 months.
!
The storage rooms must not include any ozone-generating devices like e. g. fluorescent
light sources, mercury-vapour lamps or electrical high-voltage appliances.
Humid storage rooms are not suitable.
Please make sure that condensation is not generated. The best relative air humidity is less
than 65 %.
!
In order to avoid any injuries and any kind of damage please always make use of proper
transport and lifting equipment.
The oil/air coolers are packed differently each depending on size, number and kind of transport. Unless otherwise
contractually agreed, packaging will follow the in-house packaging specifications of KTR.
2
Advice
2.4 Intended use
3
Storage, transport and packaging
3.1 Storage
3.2 Transport and packaging
