KTR-STOP
®
XS-xx-F B-xx
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
44536 EN
20 of 25
3
Please observe protection
note ISO 16016.
Drawn:
2020-03-26 Shg/Wie
Replacing:
KTR-N dated 2017-12-19
Verified:
2020-03-26 Shg
Replaced by:
•
Secure the brake pad on the fixed side via the spring clamps (component 6) and the cap screws
(component 7).
•
Mount the pad retraction set (component 8) by screwing the pin (component 8.1) into the brake pad against a
stop.
Secure the screw connection (component 8) on the brake pad additionally against working
loose, e. g. conglutinating with Loctite (average strength).
•
Repeat chapter 4.5
Setting/re-adjustment of the centering system
and chapter 4.9
Setting/re-adjustment of the
brake
.
•
Please make sure that the brake disk can rotate freely while not touching the brake pads or the brake caliper.
To facilitate the replacement of the brake pads you can unscrew the screws of the
connection plate and remove 1 out of the 2 screws alternatively. Swing the brake out of its
position.
Please note chapter 4.4 Assembly of brake.
•
Before you reactivate the brake, please observe chapter 4.8
Start-up of the brake
.
To ensure the full braking power, both disassembly and assembly have to be performed at
the highest level of purity.
•
Disassemble the brake, please observe chapter 4.11
Disassembly of the brake
.
•
Remove the pad retraction sets (component 8) and the
spring clamps (component 6), respectively.
•
Take out the brake pads (component 5) and the distance
plate (component 2).
•
Untighten each the two hexagon nuts on top of the
centering system (component 4) and remove them along
with the disk and the pressure spring.
•
Remove the brake caliper (component 1) from the guide
pin (component 3).
Illustration 18: KTR-STOP
®
XS-xx-F B-xx
!
Inspect the components/component
assemblies 2, 3 and 4 for any kind of
damages; it may be necessary to replace
the components.
Afterwards remove dirt, grease and
corrosion from the components.
5
Maintenance
5.1 Replacement of brake pads
5.2 Maintenance of the brake / replacement of single parts
