KTR-STOP
®
S-A-F B-xx
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
44591 EN
13 of 24
5
Please observe protection
note ISO 16016.
Drawn:
2019-08-13 Pz/Mro
Replacing:
KTR-N dated 2018-12-04
Verified:
2019-08-13 Pz
Replaced by:
The centering systems need to be reset with initial assembly or after having replaced brake
pads or single parts, respectively. This is the only way to ensure that the gap between the
brake disk and the brake pad on the bottom side is set to the right value and the pad does
not touch on any side.
The centering systems need to be regularly reset with wear of the brake pads. For that pur-
pose repeat the complete chapter Setting/resetting of the centering system.
•
Measure the gap between the brake disk and the brake pad on the bottom side via a feeler gauge.
•
Set the gap to the requested value by screwing the pin (component 5.1) either upwards or downwards.
•
Secure the pin (component 5.1) via the hexagon nut (component 5.2).
•
Screw the cap screws (component 4.1) into the base plate (component 3.1). The screw depth in the base
plate must be 20 mm (only valid with a thickness of brake disk of 20 mm: screwing depth must be 30 mm).
•
Seal the bores via the sealing plugs (component 4.4 and 5.3).
Illustration 13: Setting of centering system
4
Assembly
4.5 Setting/resetting of the centering system
