DATAFLEX
®
42/1000
Torque Measuring Shaft
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
49016 EN
20 of 21
2
Please observe protection
note ISO 16016.
Drawn:
2017-01-02 Shg/Koe
Replaced for:
KTR-N dated 2015-04-13
Verified:
2017-01-02 Shg
Replaced by:
In respect of environmental protection please dispose of the packaging or products on termination of their service
life in accordance with the legal regulations and standards that apply, respectively.
DATAFLEX
®
is a low-maintenance torque measuring shaft. We recommend to perform a visual inspection on the
torque measuring shaft
at least once a year
. Please pay special attention to the condition, alignment and screw
connection of the torque measuring shaft and the condition of the lamina sets of the RADEX
®
-N coupling.
!
Having started up the torque measuring shaft the tightening torques of the screws have to
be inspected during the usual inspection intervals.
Please consider our operating/assembly instructions KTR-N 47110 additionally when using
the RADEX
®
-N coupling.
If requested, we are pleased to perform the calibration of your torque measuring shaft and other services.
Contact addresses of KTR partners for spare parts and orders can be obtained from the KTR homepage at
www.ktr.com.
KTR does not assume any liability or warranty for the use of spare parts and accessories
which are not provided by KTR and for the damages which may incur as a result.
5
Disposal
6
Maintenance and service
7
Services, customer service addresses
