CLAMPEX
®
KTR 150
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
40812 EN
9 of 9
7
Please observe protection
note ISO 16016.
Drawn:
2017-11-29 Shg/Jh
Replacing:
KTR-N dated 2017-04-27
Verified:
2017-11-29 Shg
Replaced by:
STOP
Parts released or falling down may cause injury to persons or damage on the machine.
Secure the components before disassembly.
Untighten and unscrew all clamping screws evenly one after another.
The clamping elements are not self-locking. If the internal and external taper ring are still stuck, the process of
releasing should be initiated by putting light pressure on the hub in several positions on the circumference or
the hub.
Remove the clamping elements released between shaft and hub.
!
If these hints are not observed or operating conditions are not considered with the selection
of the clamping element, the operation of the clamping element may be affected.
In respect of environmental protection we would ask you to dispose of the packaging or products on termination of
their service life in accordance with the legal regulations and standards that apply, respectively.
All clamping sets consist of metal. Any metal components have to be cleaned and disposed of by scrap metal.
A basic requirement to ensure the readiness for use of the drive components is a stock of some clamping sets on
site.
Contact addresses of the KTR partners for spare parts and orders can be obtained from the KTR homepage at
www.ktr.com.
KTR does not assume any liability or warranty for the use of spare parts and accessories
which are not provided by KTR and for the damages which may incur as a result.
If used in potentially explosive atmospheres the type and size of clamping set (for category 3 only) has to be se-
lected such that the difference between the peak torque of the machine including all operating parameters and the
rated torque of the clamping hub at least corresponds to a safety factor of s = 2.
CLAMPEX
®
clamping sets are not part of directive 2014/34/EU, since
this product is a torsionally rigid, backlash-free, frictionally engaged connection with one or more taper clamp-
ing ring(s) by means of several screws.
(Clamping screws have to be secured, e. g. by means of a medium strength adhesive.)
due to the design of clamping sets a fracture/failure is not likely (frictional heat is only caused by improper
assembly/tightening torques, i. e. not with intended use).
4
Assembly
4.3 Disassembly of clamping set
5
Disposal
6
Spares inventory, customer service addresses
7
Advice regarding the use in
potentially explosive atmospheres according to EU di-
rective 2014/34/EU
