BoWex
®
FLE-PA / FLE-PAC
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
40117 EN
12 of 17
3
Please observe protection
note ISO 16016.
Drawn:
2018-09-06 Pz/Hk
Replacing:
KTR-N dated 2018-08-30
Verified:
2018-09-06 Pz
Replaced by:
Shift the flange (component 1) into the centering of the flywheel.
Short mounting
If you require short mounting, the side with marking 1 must be visible when being mounted (illustration 9).
Long mounting
If you require long mounting, align the flange such that the marking is visible (illustration 10).
Make sure the alignment of the flange is correct.
Mounting short version
Mounting long version
Illustration 9: Alignment of the coupling with short mounting
(Example: BoWex
®
FLE-PA)
Illustration 10: Alignment of the coupling with long mounting
(Example: BoWex
®
FLE-PA)
Hand-tighten the flange to the flywheel first.
Tighten the screws with a suitable torque key at the tightening torques T
A
specified in table 10 or 11.
Secure the screws against working loose by means of an adhesive (e. g. Loctite 243).
!
Please observe the manufacturer’s instructions regarding the use of adhesives.
Table 10:
Screw tightening torques for screwing the flange with nylon connection to the engine
flywheel
Size of flywheel
acc. to SAE J620d
6 ½“
7 ½“
8“
10“
11 ½“
Screw size
M8
M10
Tightening torque [Nm]
25
49
Minimum screw strength
8.8
Inch screw
5/16 - 18
3/8 - 16
Tightening torque [Nm]
24
42
Minimum screw strength
5
4
Assembly
4.7 Assembly of the flange
