KTM RC 390 2018, Instruction Manual

Page: 6 / 21

2 SETUP
4
Guideline
Screw, anti-rotation
lock, handlebar
stub (All standard
models) M5 4 Nm (3 lbf ft)
–
Check the clutch lever play. ( p. 6)
S01888-10
–
Position damping rubber 3 on both sides.
–
Join plug-in connector 4 of the mirror on both sides.
–
Position the rear mirror on both sides. Mount and tighten the
screws.
–
Position all controls in their exact positions on the handlebar.
–
Tighten all screws.
F01048-10
–
Mount reflector
5
with spring washers
6
on holding
plate
7
.
–
Mount the retaining plate on the license plate holder.
–
Mount the license plate holder.
–
Carefully loosen and remove the tension belt over the
swingarm.
Info
An assistant prevents the motorcycle from falling over.
–
Carefully loosen and remove the tension belts around the lower
triple clamp.
The vehicle is released at the front.
–
Take the vehicle off the palette together with an assistant.
Warning
Risk of injury Battery acid and battery gases cause
serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and safety
glasses.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks or open flames away from the battery.
–
Only charge batteries in well-ventilated rooms.
–
Rinse the affected area immediately with plenty of
water in the event of contact with the skin.
–
Rinse eyes with water for at least 15 minutes and
consult a doctor immediately if battery acid and
battery gases get into the eyes.
–
Fill the battery.
Info
Read the notes in the battery package.
–
Recharge the battery. ( p. 10)
–
Remove the front rider's seat. ( p. 8)