KTM Freeride E-XC NG 2018, Owner'S Manual

Page: 107 / 151

ELECTRICAL SYSTEM 16
105
–
Insert the screw and first turn counterclockwise until it
engages in the thread with a small jerk. Tighten the screw
lightly.
Finishing work
–
Install the KTM PowerPack. ( p. 108)
–
Lock the seat. ( p. 69)
–
Check that the turn signal system is functioning properly.
16.9 Checking the headlight setting
0 0 A A
0 0 B B
400726-10
–
Position the vehicle upright on a horizontal surface in front of
a light wall and make a mark at the height of the center of the
low beam headlight.
–
Make another mark at a distance B under the first marking.
Guideline
Distance
B
5 cm (2 in)
–
Position the vehicle vertically a distance A away from the
wall.
Guideline
Distance
A
5 m (16 ft)
–
The rider now sits down on the motorcycle with a full set of
protective clothing.
–
Turn the key in the ignition lock to the position .
–
Push the main switch into the position .
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the
lower mark for a motorcycle with a rider.
» If the light-dark border does not meet specifications:
–
Adjust the headlight range. ( p. 105)
16.10 Adjusting the headlight range
Preparatory work
–
Check the headlight setting. ( p. 105)
E00975-10
Main work
–
Loosen screw 1 .
–
Adjust the headlight range by pivoting the headlight.
Guideline
The boundary between light and dark must be exactly on the
lower marking for a motorcycle with rider (instructions on
how to apply the marking: Checking the headlight setting).
Info
A change in weight on the vehicle may require a correc-
tion of the headlight range.
–
Tighten screw
1
.