KTM Freeride 350, Owner'S Manual

Page: 26 / 113

RIDING INSTRUCTIONS
24
7.1
Checks and maintenance work when preparing for use
Info
Before riding the vehicle, always check its condition and operating safety.
The vehicle must be in perfect technical condition when used.
–
Check the engine oil level. ( p. 85)
–
Check the electrical system.
–
Check the brake fluid level of the front brake. ( p. 60)
–
Check the rear brake fluid level. ( p. 64)
–
Check the front brake linings. ( p. 61)
–
Check the rear brake linings. ( p. 65)
–
Check that the brake system is functioning properly.
–
Check the coolant level. ( p. 81)
–
Check for chain dirt accumulation. ( p. 50)
–
Check the chain, rear sprocket, engine sprocket and chain guide. ( p. 52)
–
Check the chain tension. ( p. 51)
–
Check the tire condition. ( p. 70)
–
Check the tire air pressure. ( p. 71)
–
Check the spoke tension. ( p. 71)
–
Clean the dust boots of the fork legs. ( p. 37)
–
Bleed the fork legs. ( p. 37)
–
Check the air filter.
–
Check the settings of all controls and ensure that they can be operated smoothly.
–
Check all screws, nuts, and hose clamps regularly for tightness.
–
Check the fuel supply.
7.2
Starting
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventilation, and do not start or run the engine in an enclosed
space without an effective exhaust extraction system.
Note
Engine failure High engine speeds in cold engines have a negative effect on the service life of the engine.
–
Always warm up the engine at low engine speeds.
B01026-11
–
Raise the motorcycle off of the stand and secure the stand with the rubber band
1
.
–
Shift gear to neutral.
Condition
Ambient temperature: < 20 °C (< 68 °F)
–
Pull the idle speed adjusting screw all the way out.
400733-01
–
Press the electric starter button .
Info
Press the electric starter button for at most 5 seconds. Wait for a least 5
seconds before trying again.
FI warning lamp lights up briefly as a functional control when starting.