12
SERVICE WORK ON THE CHASSIS
41
12.10
Installing the lower triple clamp
0
0
B01058-10
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the top steering head seal
is correctly positioned.
–
Slide on protective ring
and O-ring
.
S00836-10
–
Position the upper triple clamp with the steering.
–
Mount screw
but do not tighten yet.
–
Position the clutch line and wiring harness.
602804-10
–
Position the fork legs.
Bleeder screws
face forward.
Info
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the
upper triple clamp.
M00485-10
–
Tighten screws
.
Guideline
Screw, bottom triple clamp
M8
18 Nm
(13.3 lbf ft)
S00837-10
–
Tighten screw
.
Guideline
Screw, top steering head
M20x1.5
12 Nm (8.9 lbf ft)
