12
SERVICE WORK ON THE CHASSIS
54
C00909-01
–
Check the chain sliding piece for wear.
» If the bottom edge of the chain bolt is in line with or below the chain sliding
piece:
–
Change the chain sliding piece.
–
Check that the chain sliding piece is firmly seated.
» If the chain sliding piece is loose:
–
Tighten the screw on the chain sliding piece.
Guideline
Screw, chain sliding piece
M8
15 Nm
(11.1 lbf ft)
400985-01
–
Check the chain guide for wear.
Info
Wear can be seen on the front of the chain guide.
» If the light part of the chain guide is worn:
–
Change the chain guide.
B01713-01
–
Check that the chain guide is firmly seated.
» If the chain guide is loose:
–
Tighten the fitting on the chain guide.
Guideline
Remaining screws, chassis
M6
10 Nm
(7.4 lbf ft)
Remaining nuts, chassis
M6
10 Nm
(7.4 lbf ft)
Finishing work
–
Remove the motorcycle from the lift stand. (
12.35
Checking the frame
B01723-10
–
Check the frame for cracking and deformation.
» If the frame exhibits cracking or deformation due to a mechanical impact:
–
Change the frame.
Info
Always replace a frame that has been damaged due to a mechanical
impact. Repair of the frame is not authorized by KTM.