KTM Freeride 250 R EU, Owner'S Manual

Page: 42 / 115

12 SERVICE WORK ON THE CHASSIS
40
12.6 Installing the fork legs
B02278-10
Main work
–
Position the fork legs.
Info
The upper milled groove in the fork leg must be flush with the upper edge of
the upper triple clamp.
Position bleeder screws
 toward the front.
C00901-11
–
Tighten screws

.
Guideline
Screw, top triple clamp M8 22 Nm
(16.2 lbf ft)
–
Tighten screws  .
Guideline
Screw, bottom triple clamp M8 18 Nm
(13.3 lbf ft)
M00477-10
–
Position the brake caliper. Mount and tighten screws

with the spacers.
Guideline
Screw, front brake caliper M8 25 Nm
(18.4 lbf ft) Loctite ® 243™
–
Connect the plug-in connector

and mount the cable tie(s).
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws

.
Finishing work
–
Install the front wheel. ( p. 68)
–
Refit the headlight mask with the headlight. ( p. 76)
–
Check the headlight setting. ( p. 78)
12.7 Removing the fork protector
B02280-10
–
Remove screws  . Take off the clamp.
–
Remove screws

on the left fork leg. Take off the fork protector.
B02281-10
–
Remove screws  on the right fork leg. Take off the fork protector.