KTM 990 SUPER DUKE, Setup Instructions

Page: 5 / 17

2 SETUP
3
2.1 Unpacking and setting up the vehicle
101252-10
–
Remove the carton.
–
Remove the adhesive tape in the upper area of the motorcycle.
101253-10
–
Roll down the film at the sides.
Info
To avoid damaging the motorcycle during unpacking, leave the other films
on the vehicle until you have finished work on the vehicle.
–
Unpack the separate enclosure and check its contents on the basis of the enclosure
list.
–
Check the vehicle for transport damage.
101254-01
–
Remove the controls from the transport holder. Remove the screws and handlebar
clamps. Remove the transport holder.
101255-10
–
Remove the right-hand handlebar weight.
–
Position the controls on the right half of the handlebar but do not tighten.
–
Position the handlebar.
–
Position the handlebar clamps. Fit and slightly tighten the four screws.
–
Position the handlebar exactly.
The third marking
1
of the scale on the handlebar must align with the edge
2
of the handlebar support.
–
Tighten the four screws evenly.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
101205-10
–
Position the right combination switch. Tighten the screws.
Info
Position holding lug
A
in bore
B
.