KTM 990 ADVENTURE 2008, Owner'S Manual

Page: 63 / 102

Demounting and mounting the battery
The battery does not need to be demounted unless the motorcycle is being immobilized.
To demount the battery, remove the screws [1] and fold the underride protection [2] down.
Remove the screws
[3]
and tilt the battery cover
[4]
to the front. First disconnect the neg-
ative pole and then the positive pole. Remove the battery cover and remove the battery together
with the battery case.
Recharge the battery before and after storage. Storage temperature: 0 - 35°C (32 - 95°F).
To mount, place the battery and battery case in the battery compartment and mount the bat-
tery cover. First connect the positive pole, then the negative pole to the battery to avoid a
short circuit. Fold the battery cover up and fasten with 2 screws. Fold the underride protec-
tion up, apply Loctite 243 (screw retainer) to both screws, mount the screws and tighten to
25 Nm (19 ft.lbs).
– If electrolyte (sulphuric acid) leaks from the battery, proceed with great care. The elec-
trolyte can cause severe burns.
– In the case of skin contact rinse thoroughly with water.
– In the case of contact with the eyes, thoroughly rinse eyes with water for at least 15 min-
utes. Immediately consult a doctor.
– The battery is a closed model but can nevertheless emit explosive gases. Avoid sparks
and open fire near the battery.
– Defective batteries must be stored out of the reach of children. Ensure proper disposal
of discarded batteries.
– The screws on the underride protection must be secured with loctite 243 to prevent them
from becoming loose.
Never disconnect the battery while the engine is running. This will destroy the rectifier-
regulator.
STORAGE:
If the motorcycle is being immobilized for longer periods of time, remove and charge the
battery. Storage temperature 0 - 35°C (32 - 95°F), avoid direct sunlight.
Charge the battery every 3 months.
MAINTENANCE WORK ON CHASSIS AND ENGINE
»
62
1
1
2
3
3
4