SETUP 2
3
2.1
Transport mode
H02713-01
This vehicle was blocked for transport in the software.
To operate the vehicle, the vehicle electronics must be enabled.
This process is conducted during initial setup in KTM Dealer.net.
Enabling ensures that the initial setup in KTM Dealer.net is docu-
mented.
Enabling can be performed either temporarily, e.g. for a test ride,
or permanently for vehicle handover.
Info
Make sure that the vehicle is permanently enabled before
handing it over to the customer.
2.2
Diagnostics connector
H02681-10
Diagnostics connector
1
is located under the passenger seat.
2.3
Unpacking and setting up the vehicle
V01334-10
–
Remove the straps and the box.
V01335-01
–
Remove the adhesive tape in the upper area of the motorcycle.
–
Roll down the film at the sides.
Guideline
To avoid damaging the vehicle while setting it up, do
not remove the protective film on each component until
installing the component, and leave it on the vehicle until
work has been completed.
–
Remove the separate enclosure and unpack it. Check that the
scope of supply is complete using the enclosed packing list.
Info
The procedure for missing components is described in
the Customer Service Manual.
–
Check the vehicle for transport damage.
Summary of Contents for 890 DUKE R 2022
Page 1: ...SETUP INSTRUCTIONS 2022 890 DUKE R Art no 3214571en...
Page 2: ......
