KTM 690 SMC R AU 2014, Setup Instructions

Page: 10 / 18

3 WORK
8
100151-10
Main work
–
Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test rest potential and start potential of the
battery, and to test the alternator. With this device, you cannot overcharge the bat-
tery.
Info
Never remove lid

.
Charge the battery with a maximum of 10% of the capacity specified on the
battery housing

.
–
Switch off and disconnect the charger after charging.
Guideline
The charge current, charge voltage and charge time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use
3 months
Finishing work
–
Install the battery. ( p. 8)
–
Mount the seat. ( p. 6)
–
Set the clock. ( p. 12)
3.5 Installing the battery
B01975-11
Main work
–
Insert the battery into the battery compartment with the terminals facing rearward.
Battery (YTZ10S)
–
Position retaining bracket

and mount and tighten screws

.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
–
Position the positive cable and mount and tighten the screw.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
–
Position positive terminal cover

.
–
Position negative cable

and mount and tighten the screw.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
B01976-10
–
Position EFI control unit

.
–
Mount battery cover

.
Finishing work
–
Mount the seat. ( p. 6)
–
Set the clock. ( p. 12)