KTM 690 Enduro R USA, Owner'S Manual

Page: 172 / 207

20 TROUBLESHOOTING
170
Faults Possible cause Action
The engine does not turn when the
starter button is pressed Operating error
–
Carry out the start procedure. ( p. 47)
Battery is discharged
–
Recharge the battery. x ( p. 128)
Fuses 1 , 2 , 3 are blown
–
Change the fuses of individual power consumers.
( p. 134)
Main fuse burned out
–
Change the main fuse. ( p. 131)
No ground connection present
–
Check the ground connection.
Engine turns only if the clutch lever is
drawn The vehicle is in gear
–
Shift gear to neutral.
The vehicle is in gear and the side
stand is folded out
–
Shift gear to neutral.
Engine turns but does not start. Operating error
–
Carry out the start procedure. ( p. 47)
Fuse 3 blown
–
Change the fuses of individual power consumers.
( p. 134)
Coupling of fuel hose connection not
connected
–
Reconnect coupling of fuel hose connection.
Defect in fuel injection system
–
Read out the fault memory using the KTM diag-
nostics tool.
x
Throttle opened while starting
–
When starting, DO NOT open the throttle
–
Carry out the start procedure. ( p. 47)
Engine has too little power. Air filter is very dirty
–
Remove the air filter. x ( p. 81)
–
Install the air filter. x ( p. 82)
Fuel filter is very dirty
–
Check the fuel pressure.
x
Defect in fuel injection system
–
Read out the fault memory using the KTM diag-
nostics tool.
x
Map
‑
Select switch incorrectly adjusted
–
Adjust the engine characteristic. ( p. 152)