TUNING THE CHASSIS
63
9.12
Handlebar position
0
0
B
B
0
0
A
A
400271-11
On the upper triple clamp, there are 2 holes at a distance
to each other.
Distance
between holes
15 mm (0.59 in)
The holes on the handlebar support are placed at a distance
from the center.
Distance
between holes
3.5 mm (0.138 in)
The handlebar can be mounted in 4 different positions. In this way, the handlebar can be
installed in the position most comfortable for the rider.
9.13
Adjusting handlebar position
x
0
0
2
2
0
0
1
1
0
0
2
2
1
1
B00375-10
–
Remove the four screws
. Remove the handlebar clamp. Remove the handlebar and
lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
–
Remove the two screws
. Remove the handlebar support.
–
Place the handlebar support in the required position. Fit and tighten the two screws
.
Guideline
Screw, handlebar support
M10
40 Nm
(29.5 lbf ft)
Info
Position the left and right handlebar supports evenly.
Summary of Contents for 690 Enduro R AUS
