30/ENGINE - WORK ON INDIVIDUAL PARTS
148
–
Replace the starter idler gear and/or needle bushing.
–
Check the teeth and seating of the torque limiter
for damage and wear.
» If there is damage or wear:
–
Replace the torque limiter and/or needle bushing.
–
Check freewheel gear
and bearing when removed for damage and wear.
» If there is damage or wear:
–
Replace the freewheel gear and/or the bearing.
–
Check the freewheel
when removed for damage and wear.
» If there is damage or wear:
–
Replace the freewheel.
–
Check the toothing of the starter motor
for damage and wear.
» If there is damage or wear:
–
Replace the starter motor.
–
Clamp the minus (negative) cable of a 12 Volt power supply to the starter motor housing. Briefly connect the plus (positive) cable
of the power supply to the starter motor connection.
» If the starter motor does not turn when you close the power circuit:
–
Replace the starter motor.
–
Replace the O-ring
of the starter motor.
19.40
Removing freewheel
300127-10
–
Extract the lock ring
from the groove using suitable pliers.
300128-10
–
Compress the expansion ring
and remove it, using suitable pliers.
–
Take the freewheel
out of the primary gear.
19.41
Checking freewheel
300131-10
–
Insert the freewheel gear
in the primary gear
, turning the primary gear clock-
wise; do not twist!
–
Check the locking action of the freewheel gear
.
» If the primary gear does not turn clockwise or if it does not lock counterclock-
wise:
–
Remove the freewheel. (
–
Turn the freewheel 180°.
–
Install the freewheel. (
Summary of Contents for 690 Enduro AUS 2010
Page 2: ......
