41/THROTTLE VALVE BODY
166
–
Adjust the basic setting of the motor drive. (
400537-51
–
Use
"Continue"
to start the
"Checking the position of the throttle grip sensor"
menu.
The motor drive keeps the throttle valve in the emergency running position.
–
Check the voltage value.
Info
The
"Continue"
button only appears if the measured value equals the set-
point value.
Throttle grip sensor
Voltage
"APAD"
0.70… 0.74 V
» If the displayed value is not equal to the setpoint value:
–
Close the menu with
"Exit"
.
–
Adjust the basic setting of the motor drive. (
–
Close the menu with
"Continue"
.
25.2
Adjusting the basic setting of the motor drive
Condition
The diagnostics tool is connected.
–
Remove the air filter box. (
601136-10
–
Disconnect the connector of the motor drive
DR
.
–
Switch on the ignition by turning the ignition key in the position
(690 Enduro EU, 690 Enduro AUS/UK)
(690 Enduro USA).
–
Select model.
–
Select
"ECU Diagnostics"
.
–
Highlight
"EPT throttle motor drive control LC4"
control unit.
–
Press
"Continue"
.
–
Select
"Adjustment"
.
–
"Please enter the password:"
–
Press
"Continue"
.
–
Select
"Adjusting the basic setting of the motor drive"
.
–
Press
"Continue"
.
400786-60
–
Read the information page in the KTM diagnostics tool and use
"Continue"
to open
the
"Adjusting the position of the throttle position sensor in circuit A"
menu.