KTM 690 DUKE R AUS/UK, Owner'S Manual, Page: 85 / 187

BRAKES
83
700153-01
–
Disconnect spring

.
–
Move the foot brake lever back and forth between the end stop and the contact to the
foot brake cylinder piston and check free travel

.
Guideline
Free travel at foot brake lever 3… 5 mm (0.12… 0.2 in)
» If the free travel does not meet specifications:
–
Adjust the basic position of the foot brake lever.
x
( p. 83)
–
Reconnect spring

.
11.7
Adjusting the basic position of the foot brake lever
x
Warning
Danger of accidents Brake system failure.
–
If there is no free travel on the foot brake lever, pressure builds up on the rear brake circuit. The rear brake can fail due to over-
heating. Adjust free travel on foot brake lever according to specifications.
302084-10
–
Disconnect spring

.
–
Remove screw

.
–
Loosen nut

and turn it back with ball joint

until the maximum amount of free
travel is reached.
–
To adjust the basic position of the foot brake lever individually, loosen nut

and turn
screw

accordingly.
Info
The range of adjustment is limited.
–
Turn ball joint

as required until free travel

is reached. If necessary, adjust the
basic position of the foot brake lever.