2
SETUP
3
2.1
Unpacking and setting up the vehicle
E00601-01
–
Remove the box and the plastic packaging.
Info
To avoid damaging the motorcycle while mounting the handlebar, leave the
film on the fuel tank until all of the work on the motorcycle has been fin-
ished.
–
Check the vehicle for transport damage.
–
Unpack the separate enclosure and check its contents on the basis of the enclosure
list.
(690 Duke US)
–
Ensure that the reflector is mounted on the license plate holder.
E00602-01
–
Remove the controls from the transport holder. Remove the screws and handlebar
clamps. Remove the transport holder.
K00451-01
–
Remove the right-hand handlebar weight.
–
Position the controls on the right half of the handlebar. Tighten the screws.
Guideline
Screw, throttle grip
M5
3.5 Nm
(2.58 lbf ft)
E00174-10
–
Position the handlebar.
Marking
0
on the scale on the handlebar is situated in the middle of the han-
dlebar clamp.
–
Position the handlebar clamps. Tighten the screws evenly.
Guideline
Screw, handlebar clamp
M8
20 Nm
(14.8 lbf ft)
–
Mount and tighten the right handlebar weight.
–
Check the throttle grip for smooth operation.
K00452-01
–
Position the controls on the left half of the handlebar.
–
Position all controls in their exact positions on the handlebar. Tighten all screws.
