KTM 690 Duke 2019, Setup Instructions

Page: 9 / 21

WORK 3
7
3.1 Removing the passenger seat
V00043-10
–
Insert the ignition key in seat lock
1
and turn it clockwise.
–
Raise the rear of the passenger seat cover, push it toward the
rear, and remove it upward.
–
Remove the ignition key from the seat lock.
3.2 Mounting the passenger seat
K00421-10
–
Hook holding lugs
1
of the passenger seat onto the storage
compartment, lower the rear and push forward.
–
Press passenger seat downward until it clicks into place.
Warning
Danger of accidents
The seat can come loose from the
anchoring if it is not mounted correctly.
–
After assembly, check whether the seat is correctly
locked and cannot be pulled up.
–
Finally, check that the passenger seat is correctly mounted.
3.3 Charging the 12-V battery
Warning
Risk of injury
Battery acid and battery gases cause serious chemical burns.
–
Keep 12 V batteries out of the reach of children.
–
Wear suitable protective clothing and safety glasses.
–
Avoid contact with battery acid and battery gases.
–
Keep sparks or open flames away from the 12 V battery.
–
Only charge 12 V batteries in well-ventilated rooms.
–
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
–
Rinse eyes with water for at least 15 minutes and consult a doctor immediately if battery acid and
battery gases get into the eyes.
Note
Environmental hazard 12 V batteries contain environmentally hazardous materials.
–
Do not dispose of 12 V batteries as household waste.
–
Dispose of 12 V batteries at a collection point for used batteries.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.