12
BRAKE SYSTEM
52
C00033-10
Main work
–
Remove the lock washer
.
–
Remove screw
.
C00032-01
–
Remove the brake linings.
–
Clean brake caliper and brake caliper support.
12.9
Installing the front brake linings
Warning
Danger of accidents
Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Danger of accidents
Reduced braking efficiency due to use of non-approved brake linings.
–
Brake linings available from accessory suppliers are often not tested and approved for use on KTM vehicles. The construc-
tion and friction factor of the brake linings and therefore the brake power can differ considerably from the original KTM
brake linings. If brake linings are used that differ from the originals, there is no guarantee that they comply with the origi-
nal license. The vehicle no longer corresponds to the condition at delivery, and the warranty is no longer valid.
Preparatory work
–
Check the brake discs. (
C00032-01
Main work
–
Insert new brake linings.
Info
Always change the brake linings in pairs.
Ensure that the brake linings are correctly positioned in the retaining spring.
C00034-10
–
Mount and tighten screw
.
Guideline
Screw; front brake lining
M6
10 Nm (7.4 lbf ft)
–
Mount lock washer
.
Finishing work
–
Install the front wheel.
Summary of Contents for 65 SX 1999
Page 1: ...OWNER S MANUAL 2016 65 SX Art no 3213328en...
Page 2: ......
