Main fuse
Located near the battery under the seat, the main fuse
1
protects all power
consumers.
Replace a blown fuse only with an equivalent one. If a new fuse that has
just been set in gets blown again, you are strongly advised to have it
inspected by a KTM dealer.
The fuse capacity is 20 Ampere.
!
CAUTION
!
U
NDER NO CIRCUMSTANCES IS A STRONGER FUSE ALLOWED TO BE SET IN OR A FUSE
ALLOWED TO BE
“
REPAIRED
”. A
N INEXPERT TREATMENT COULD DAMAGE THE WHOLE
ELECTRICAL INSTALLATION
!
Fuses for individual power-consuming units
Additional fuses separately protecting different power-consuming units are
mounted under the headlight mask.
For instructions to remove and mount the headlight mask please refer to
"Exchanging the headlight lamp".
Fuse
2
(10 Ampere) protects the following power-consuming units:
– headlight
– parking light
Fuse
3
(10 Ampere) protects the following power-consuming units:
– flasher lights
– brake light
– horn
– radiator fan motor
Fuse
4
(10 Ampere) protects the following power-consuming units:
– ignition
– starter system
Replace a blown fuse only with an equivalent one. If a new fuse that has
just been set in gets blown again, you are strongly advised to have it
inspected by a KTM dealer.
!
CAUTION
!
U
NDER NO CIRCUMSTANCES IS A STRONGER FUSE ALLOWED TO BE SET IN OR A FUSE
ALLOWED TO BE
“
REPAIRED
”. A
N INEXPERT TREATMENT COULD DAMAGE THE WHOLE
ELECTRICAL INSTALLATION
!
Exchanging the headlight lamp
Remove the headlight mask:
– Remove screws
5
on the left and on the right side.
– Depress the front section of the fender, pull the headlight mask upwards,
unhook it from the lower part of the fender, then swing it forwards.
Exchanging the headlight lamp
– Disconnect plug
6
from the bulb.
– Remove the rubber cap
7
– Unhook the retaining bracket, then remove the bulb.
– When inserting the new bulb make sure that the wider of the 3 tongues
8
is located in the corresponding groove in the socket.
!
CAUTION
!
N
EVER TOUCH THE GLASS OF THE BULB WITH YOUR FINGERS
. T
HE GLASS OF THE BULB
MUST REMAIN ABSOLUTELY FREE FROM GREASE
. H
EAT WILL OTHERWISE CAUSE THE
GREASE TO EVAPORATE AND SETTLE DOWN ON THE REFLECTOR
.
– Hook in the retaining bracket, mount the rubber cap and connect the
plug to the bulb.
Mounting the headlight mask
– Appropriately position the headlight mask. The headlight must be
located below the cockpit.
– Depress the front part of the fender, pull the headlight mask upwards and
insert the retaining pins
9
into the corresponding bores of the fender.
– Mount the screws
5
.
Replacing the parking-light bulb
Disassemble the headlight as described above and simply pull the bulb
socket
bk
out of the reflector.
ENGLISH
23
1
2
3
4
5
6
7
10
9
8
Summary of Contents for 640 LC4R
