KTM 50 SX 2015, Setup Instructions

Page: 5 / 13

2 SETUP
3
2.1 Unpacking and setting up the vehicle
201948-10
–
Open the box.
Info
To avoid damaging the vehicle while setting it up, do not remove the protec-
tive film on each component until installing the component, and leave it on
the vehicle until work has been completed.
–
Remove the separate enclosure and unpack it. Check that the scope of supply is
complete on the basis of the enclosed packing list.
–
Lift the vehicle out of the box with the assistance of another person.
–
Raise the motorcycle with a lift stand. ( p. 4)
–
Check the vehicle for transport damage.
–
Remove the protective film from the handlebar.
201949-10
–
Position the handlebar with handlebar clamps.
–
Mount and tighten screws.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
–
Check the handlebar position.
» If the handlebar position is not adjusted as required by the customer:
–
Adjust the handlebar position. ( p. 4)
–
Remove the screw of the brake line guide. Position the brake line. Mount the brake
line guide again and tighten the screw.
–
Check the wiring harness, cables, and brake line for freedom of movement and cor-
rect routing.
–
Check that the controls on the handlebar are correctly positioned and firmly seated.
201950-10
–
Mount the footrests with the springs and pins. Secure the pins using the washers
and cotter pins.
Pliers for footrest spring (58429083000)
–
Fill up with fuel. ( p. 5)
(50 SX Mini)
–
Fill up with oil. ( p. 6)
–
Remove the motorcycle from the lift stand. ( p. 4)
–
Park the vehicle on the plug-in stand.
–
Print out the current PDI form found on KTM DEALER.NET and perform the delivery
inspection.