KTM 350 XC-F, Owner'S Manual

Page: 45 / 113

11 SERVICE WORK ON THE CHASSIS
43
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 37)
400738-11
Main work
–
Move the handlebar to the straight-ahead position. Move the fork legs to and fro in
the direction of travel.
No play should be noticeable in the steering head bearing.
» If there is noticeable play present:
–
Adjust the play of the steering head bearing. ( p. 43)
–
Move the handlebar to and fro over the entire steering range.
The handlebar must be able to move easily over the entire steering range. No
resting locations should be noticeable.
» If click positions are noticeable:
–
Adjust the play of the steering head bearing. ( p. 43)
–
Check the steering head bearing and change if necessary.
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 37)
11.12 Adjusting the play of the steering head bearing
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 37)
–
Remove the handlebar cushion.
102159-10
Main work
–
Loosen screw

. Remove screw

.
–
Loosen and retighten screw

.
Guideline
Screw, top steering head M20x1.5 12 Nm (8.9 lbf ft)
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Fully tighten screws

.
Guideline
Screw, top triple clamp M8 17 Nm
(12.5 lbf ft)
–
Mount and tighten screw  .
Guideline
Screw, top steering stem M8 20 Nm
(14.8 lbf ft) Loctite ® 243™
–
Check the steering head bearing play. ( p. 42)
Finishing work
–
Mount the handlebar cushion.
–
Remove the motorcycle from the lift stand. ( p. 37)
11.13 Greasing the steering head bearing
800010-10
–
Remove the lower triple clamp. ( p. 40)
–
Install the lower triple clamp. ( p. 41)