6
CONTROLS
12
6.6
Map
‑
Select switch for the basic setting (All SX
‑
F models)
102129-10
The
Map
‑
Select
switch for basic setting
is fitted under the air filter box lid.
Possible states
1
SOFT
–
The mapping with reduced peak performance for better ride-
ability is activated. The
Launch Control
can be activated.
2
ADVANCED
–
The mapping for performance with a very direct response
is activated. The
Launch Control
can be activated.
3
-
9
,
0
STANDARD
–
The mapping for performance with a balanced response
is activated. The
Launch Control
cannot be activated.
The
Map
‑
Select
switch for the basic setting is used to preselect the engine characteris-
tics.
6.7
Map
‑
Select switch for ride mode (All SX
‑
F models)
C00914-10
The
Map
‑
Select
switch for vehicle operation
is fitted on the right side of the handle-
bar.
Possible states
STANDARD
–
In this position, STANDARD mapping is always activated.
SOFT or ADVANCED
–
In this position, the mapping that is set on
the
Map
‑
Select
switch for the basic setting is activated.
The engine characteristics can be changed on the handlebar using the
Map
‑
Select
switch for vehicle operation. This change is activated while the engine is
idling or on restarting.
In addition, the
Map
‑
Select
switch controls the
Launch Control
6.8
Launch control
The
Launch Control
assists the rider in optimally starting the motorcycle at the beginning of a race. The maximum speed of the engine
with the throttle valve fully opened (full throttle) is reduced. After the start, it is gradually increased up to the maximum engine speed.
Throughout this procedure, the rider opens the throttle fully and the best possible acceleration is achieved.
The clutch must be activated exactly as it would be without an active
Launch Control
.
The Launch Control is deactivated in the following cases (FI warning lamp (MIL) no longer flashes):
–
After full throttle, the throttle valve was closed by more than 1/3 of the way.
–
There is no start within 3 minutes.
Info
Several seconds after the vehicle starts,
Launch Control
is deactivated automatically.
To reactivate
Launch Control
, the engine must first be switched off for at least 10 seconds for safety reasons. This must occur
regardless of whether a start occurred.
6.9
Overview of indicator lamps
K00183-01
Possible states
FI
warning lamp (
MIL
) lights up/flashes orange
–
The OBD (on-board
diagnosis) has detected an emission- or safety-critical error.
FI
warning lamp (
MIL
) flashes orange rapidly
–
The
Launch Control
is
activated.
(XC
‑
F US)
The low fuel warning lamp lights up orange
–
The fuel level has
reached the reserve mark.
