KTM 350 EXC-F AUS 2014, Setup Instructions

Page: 11 / 24

3 WORK
9
3.4 Refitting the headlight mask with the headlight
B01561-11
Main work
–
Connect the electric plug connector
1
.
B01560-11
–
Position the headlight mask and fix it with the rubber band
2
.
Info
Ensure that the retaining lugs engage in the fender.
–
Position the brake line and wiring harness. Put the clamp on, mount and tighten
screw
3
.
Finishing work
–
Check the headlight setting. ( p. 9)
3.5 Checking the headlight setting
400726-10
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark a distance
B
under the first mark.
Guideline
Distance
B
5 cm (2 in)
–
Position the vehicle vertically a distance
A
away from the wall.
Guideline
Distance
A
5 m (16 ft)
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver.
» If the light-dark border does not meet specifications:
–
Adjust the headlight range. ( p. 9)
3.6 Adjusting the headlight range
Preparatory work
–
Check the headlight setting. ( p. 9)
B01620-10
Main work
–
Loosen screw
1
.
–
Adjust the headlight range of the headlight by moving it up or down.
Guideline
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with driver (instructions on how to apply the mark: Checking the
headlight setting).
Info
A change in weight on the vehicle may require a correction of the headlight
range.