KTM 350 EXC-F 2017, Owner'S Manual

Page: 95 / 129

15 ELECTRICAL SYSTEM
93
E00499-10
Main work
–
Remove the screw and carefully remove diffuser

.
–
Press the turn signal bulb

carefully into the socket, turn it counterclockwise by
about 30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers, and keep it free from grease.
–
Press the new turn signal bulb carefully into the socket and turn it clockwise until
it stops.
Turn signal (RY10W / socket BAU15s) ( p. 114)
–
Position the diffuser.
–
Insert the screw and first turn it counterclockwise until it engages in the thread.
Tighten the screw slightly.
Finishing work
–
Check that the turn signal system is functioning properly.
15.10 Checking the headlight setting
400726-10
–
Position the vehicle upright on a horizontal surface in front of a light wall and make
a mark at the height of the center of the low beam headlight.
–
Make another mark at a distance

under the first mark.
Guideline
Distance

5 cm (2 in)
–
Position the vehicle vertically at a distance

away from the wall.
Guideline
Distance 
5 m (16 ft)
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly on the lower mark for a
motorcycle with rider.
» If the light-dark border does not meet specifications:
–
Adjust the headlight range. ( p. 93)
15.11 Adjusting the headlight range
Preparatory work
–
Check the headlight setting. ( p. 93)
V00369-10
Main work
–
Loosen screw  .
–
Adjust the headlight range by pivoting the headlight.
Guideline
The boundary between light and dark must be exactly on the lower marking for
a motorcycle with rider (instructions on how to apply the marking: Checking the
headlight setting).
Info
A change in weight on the vehicle may require a correction of the headlight
range.
–
Tighten screw

.