19
CARBURETOR
193
303351-11
–
Mount the hoses on the carburetor.
–
Position the float chamber.
–
Mount and tighten screws
8
.
Guideline
Other screws, carburetor
M4
2 Nm (1.5 lbf ft)
303354-10
–
Position the jet needle in the throttle slide.
–
Mount and tighten needle screw cap
9
.
Guideline
Needle screw cap
M8
3.5 Nm
(2.58 lbf ft)
19.13
Checking/adjusting the float level
Condition
The carburetor and float chamber have been removed.
303357-10
–
Tilt the carburetor sideways, preventing the fulcrum pin from falling out.
–
Tilt the carburetor until the float is resting against the float needle valve, but the
float needle valve is not being pressed together.
60°
» If the edge of the float is not parallel (max. 1° deviation upwards) to the sealing
area of the float housing in this position:
–
Adjust the float level by bending the float lever.
